All Seasons Builders All articles
Maintenance & Repair

Water Travels Sideways: Why British Damp Is Diagnosed at Ground Level, Not in the Clouds

All Seasons Builders
Water Travels Sideways: Why British Damp Is Diagnosed at Ground Level, Not in the Clouds

Photo: Junyu-K, CC BY-SA 4.0, via Wikimedia Commons

Ask a room of homeowners what causes damp and most will gesture upwards, towards the sky. Rain, they will say, and the British climate, and the fact that the house is old. It is an understandable conclusion and, in the majority of cases, the wrong one. Rain is the delivery mechanism. The fault is nearly always horizontal: a raised patio, a blocked gully, a bridged damp-proof course, an airbrick sealed by a previous owner's landscaping.

Treating damp as a weather problem leads directly to weather-proofing: sealants, waterproof render, injected courses sold on a doorstep. Treating it as a water-path problem leads to a far cheaper and more durable set of repairs.

The rain takes the blame; the ground gets away with it

Water at the base of a wall has three routes in. It can rise by capillary action where the damp-proof course is absent, damaged or bridged. It can penetrate laterally, driven through the wall by saturated ground or by a paving surface laid above the internal floor level. Or it can arrive as vapour from below a suspended timber floor with no ventilation, condensing on the cold side of the structure. All three are ground-level phenomena. None is solved by a coat of Thompsons on the outside.

Two courses above the ground: the rule most often broken

External ground level should sit at least 150mm, roughly two brick courses, below the damp-proof course. This is not decoration; it is the entire working principle of the detail. It is routinely lost to block paving laid on top of an existing drive, to a raised patio installed for level access, to gravel beds and planters banked against the wall, and to decking whose frame sits directly against the masonry.

The repair is usually physical rather than chemical: lower the ground, introduce a channel or ACO drain, or form a dry area. On a solid-walled cottage, lowering a path by two courses has resolved damp that three injections failed to touch.

Paving, falls and the drainage nobody checks

Hard surfaces should fall away from the building, commonly between 1:60 and 1:80, and gullies should sit below the damp-proof course rather than above it. Silted gullies, cracked salt-glazed pipes under a 1930s semi, a soakaway that has filled with fines, an overflowing water butt discharging against the wall: each delivers a steady, small volume of water to exactly the wrong place. A CCTV drain survey costs a fraction of the internal replastering it prevents.

Gutters and downpipes: cheap to fix, expensive to ignore

Blocked gutters and leaking hoppers are the most common cause of damp patches high on an internal wall, and the most frequently misdiagnosed as roof failure. Water running down the back of a downpipe, or overflowing at a joint, soaks the wall head and appears as a stain a metre lower and two rooms away. Clear gutters twice a year, once after leaf fall in late autumn and once in early spring, and check that downpipes discharge into a gully or shoe rather than onto the paving.

The damp-proof course itself

Properties built before the late nineteenth century frequently have no damp-proof course at all, or a slate or bitumen course that has perished. Later injected courses are only as good as the injection: holes drilled at the wrong height, or a course defeated by a render plinth bridging it externally and a cement-based plaster bridging it internally, achieve nothing. Any diagnosis should include a check for bridging on both faces.

Airbricks: the forgotten half of the system

Suspended timber ground floors depend on cross-ventilation. Airbricks are frequently painted over, blocked by a new patio, buried by soil, or replaced by a homeowner who disliked the draught. The result is stagnant, humid air beneath the floor, joist ends that rot, and condensation appearing inside the house as musty smells and cold-floor mould. Sleeve the airbrick through any cavity, keep the external opening clear, and never seal one to solve a draught; fix the draught at floor level instead.

Breathability, and the danger of sealing moisture in

On older solid-walled properties, cement render and cement pointing trap moisture in the wall, driving it inward. Modern waterproof masonry paints and silicone sealants do the same. Lime-based mortars and renders allow the wall to dry outward, which is the mechanism the building was designed around. Before specifying a waterproof coating for a damp wall, establish empirically whether the wall is wet because water is entering or because it cannot escape.

An outside-in inspection routine

Work from the outside inward, and do it in wet weather if possible.

  1. Walk the perimeter. Note ground levels against the damp-proof course at every point, including under decking and behind planters.
  2. Watch the rainwater goods. Observe gutters and downpipes during heavy rain; leaks are obvious when you are looking for them.
  3. Check the paving falls. A spirit level on the patio, a hose test at the low corner.
  4. Inspect every airbrick. Clear, sleeved, unobstructed.
  5. Look at the base of the wall internally. Skirting-level tide marks and blown plaster suggest rising or lateral moisture; a horizontal line at a consistent height across several rooms is a strong signal.
  6. Read the mould. Mould concentrated in cold corners and behind furniture points to condensation; a band along the base of a wall points to ground moisture; a patch near a chimney breast is often hygroscopic salt from historic soot.
  7. Check the roof space and wall head once, to rule out the sky before blaming the ground.

Diagnosing before treating

Genuine rising damp exists, but it is diagnosed far more often than it occurs. A moisture meter reading is not a diagnosis; salts, contaminated plaster and condensation all produce high readings. The financial argument for sequence is straightforward: fix drainage and levels first, restore ventilation second, repair plaster last. Reversed, the same money buys a cosmetic repair over an unresolved cause, and the stain returns with the first wet November.

All Articles

Related Articles

Opening Up the Ground Floor: Load Paths, Party Walls and the Consents Behind a Wall Removal

Opening Up the Ground Floor: Load Paths, Party Walls and the Consents Behind a Wall Removal

Reading the Sky Before You Pour: Why the First Three Days Decide the Fate of Concrete, Render and Mortar

Reading the Sky Before You Pour: Why the First Three Days Decide the Fate of Concrete, Render and Mortar

Six, Twelve, Twenty-Four: A Seasonal Diary for Inspecting a New Extension

Six, Twelve, Twenty-Four: A Seasonal Diary for Inspecting a New Extension